New Products for the LC!

[Luigi]

Some new products from CA Tuned Off Road, just in time for the holidays! Upper multipurpose shelf for the cargo area. Easy install, retains factory strap points, no drilling or cutting with an integrated slot for a Baja Designs dome light, much needed light for the cargo area that can be easily tapped into one of the two cargo lights. The bull bar does not conflict with any factory sensors, easy to install no cutting or trimming and direct bolt on. Easily mount any additional lights! These, as well as their on board air kit is available.

Land Cruiser

 

[uraniumrich]

Some new products from CA Tuned Off Road, just in time for the holidays! Upper multipurpose shelf for the cargo area. Easy install, retains factory strap points, no drilling or cutting with an integrated slot for a Baja Designs dome light, much needed light for the cargo area that can be easily tapped into one of the two cargo lights. The bull bar does not conflict with any factory sensors, easy to install no cutting or trimming and direct bolt on. Easily mount any additional lights! These, as well as their on board air kit is available.

Land Cruiser

Where does the front license plate mount with the bull bar attached?

 

[cvx5832LC]

Looks like the DME was repositioned?

 

[motodog71]

Some new products from CA Tuned Off Road, just in time for the holidays! Upper multipurpose shelf for the cargo area. Easy install, retains factory strap points, no drilling or cutting with an integrated slot for a Baja Designs dome light, much needed light for the cargo area that can be easily tapped into one of the two cargo lights. The bull bar does not conflict with any factory sensors, easy to install no cutting or trimming and direct bolt on. Easily mount any additional lights! These, as well as their on board air kit is available.

Land Cruiser

Very nice LC, looks like running 37s? What is your wheel, tire and lift setup.

 

[Luigi]

Where does the front license plate mount with the bull bar attached?

I would probably remount it to one of these two positions.

 

[Luigi]

Very nice LC, looks like running 37s? What is your wheel, tire and lift setup.

Dobinsons MRR extended travel kit w/ adjustable rear sway bar end links, JBA Offroad UCA’s, durobumps rear bump stop, Dr. KDSS bolt on trackbar correction kit (B.O.T.C.K) which will be available soon. 37x12.5R17 Milestar Patagonia MT2 on Reika 17x8.5 0 offset. Minimal cutting/trimming required.

 

[Luigi]

Looks like the DME was repositioned?

Yes. Pretty straight forward. Tight fitting for sure, but works. Haven’t really seen any other options for on board air kits for the 24 LC yet other than CA Tuned Offroad. I’ve seen some run it in the back in a couple locations like on an interior Molle panel.

 

[b407driver]

They need to sell their ARB Twin compressor mounting bracket separately. That's a stupid 'bundle' price for a piece of metal (works out to ~$400 for a bracket).

 

[jenos96]

Nice to see more products for the tech, but tbh I think victory 4x4 wins by a long shot in terms of read shelf design. I mean the holes in this one are enormous and no mounting points for accessory equipment