Hello all, can someone with access to TIS post the component and wiring diagram for the digital rear view mirror? Trying to to install a radar detector using a Blendmount with a mirror power tap. Don't want to break anything! Thanks in advance.
Need Wiring & Component Diagram for Digital Rear View Mirror from TIS
- Thread starter YotaPilot
- Start date
This is what I found on Blendmounts site under the mount I ordered this morning.
Attachments
- Moderator
- #5
I added it to the orig post
How did it turn out? What wires did you use?
Bump for info.
I tapped into the right middle harness (white plastic, red to red, black to black) for my Uniden radar detector.
Attachments
any advice on removing the cover no 2? The pdf linked doesn't show the instructions.
I'd been trying to wire my Valentine One just under the mirror with a mirror mount. I assume the wiring behind(/above?) the mirror varies depending on trim & features.
Unlike users above, my RJ11 to red/black didn't match up with the white connector (mirror power) in the same red-to-red, black-to-black format. For me, red-to-red, and black-to-white/black twisted is the only combination I could find to give me switched power.
I've got a Vantrue dash cam going in next and am going to likely have to route it around the windshield, through the A pillar and to the fuse box. We'll see how it goes.
Unlike users above, my RJ11 to red/black didn't match up with the white connector (mirror power) in the same red-to-red, black-to-black format. For me, red-to-red, and black-to-white/black twisted is the only combination I could find to give me switched power.
I've got a Vantrue dash cam going in next and am going to likely have to route it around the windshield, through the A pillar and to the fuse box. We'll see how it goes.
Last edited:
Similar threads
