Need Dash Speaker install help

[Cash]

Replacing dash speakers and I cannot for the life of me figure out how to get the wire harness clips onto the speaker. It is so tight and I can't get them on. I don't want to break the posts on the speaker. Assuming there is trick or something I don't know I need to do to get them on?

Any help is greatly appreciated!

Speakers:

JL Audio C2-350x 3.5” C2 Series 2-way 4-ohm Coaxial Car Speakers

JL Audio C2-350x • 80W Peak 50W RMS 3.5” C2 Series 2-way 4-ohm Coaxial Car Speakers • 40 watts Peak Each 25 watts RMS Each • 3/4" Silk Dome tweeters • Mineral-Filled Polypropylene cone material • Impedance: 4 ohms • Sensitivity: 86 dB

www.sonicelectronix.com

Wire Harness:

Amazon.com

 

[Nuke]

Appears to be standard slip-on's to me. If the female side is wide enough, a bit more force?

 

[Cash]

Appears to be standard slip-on's to me. If the female side is wide enough, a bit more force?

Thanks man. Ended up really forcing with a little wiggle back and forth and it finally went. I think one of the harness quick slides was a little off because the 2nd one went on much easier. Can't believe the difference in sound. Everyone saying a dash speaker upgrade makes the most impact for the base 6 speaker system is right.