Anyone find a good GMRS mounting solution?

[Dualonymous]

Debating finally going to a vehicle GMRS unit instead of handheld. Has anyone found a mounting solution they like?

 

[EOD Guy]

There may be room for the Midland MX575 to fit behind the trim panel located just below the AC controls, IDK. The switch blank could be drilled and split to allow the cable to exit. In my photo below I have a remote radar button installed. I'm thinking you could drill a hole in the switch blank the same diameter as the cord, split the bottom of the blank and squish the cord through the split and rest in the hole. Would make for a very clean install.

That entire dash section is held on by one 10mm bolt and many plastic "Christmas tree fasteners. Here is a link for the removal for an amp install